Are you considering buying a compact concrete plant (купить компактный бетонный завод)? If so, you should carefully weigh the pros and cons of what could occur before you even begin to use the concrete plant. For example, you may end up choosing a compact concrete plant that is the wrong design for your business. This costly mistake could lead to a loss in revenue, or you may end providing a product that is not the best concrete mix for the job.
The following are several factors that you should consider before you order your concrete plant.
Durability
It is important to know how durable the concrete plant you want to buy is before you order it. You want to make sure the equipment has power to handle the task at hand.
This means that you should know the compressive strength. For example, reinforced concrete is typically used for slabs and footing on grade. It ranges from 3,000 to 4,000 psi.
When reinforced concrete is used on grinders, beams and suspended slabs, its required psi is between 3,500 to 5,000. If you are planning to use concrete that has not been reinforced, it will require a different strength.
With that said, you will need to ensure that the compact concrete plant that you buy will have the durability needed to complete the job. Learn more about compact concrete plant: https://batchingplant.ru/kompaktnyy-betonnyy-zavod/.
Slump
Concrete slump is simply the evenness or uniformity of the concrete once it is poured. Typically, the slump required will be low, but it can change depending on how and where it will be poured. Other factors such as slope, reinforcement spacing and formwork type also effect the slump level.
The slump levels are defined by the standards set by the ACI (American Concrete Institute), but there are some recommendations you can consider.
Footings should have slump levels at a minimum of 1 inch and a maximum of 4 inches.
For pavement, the minimum slump level should be 2 inches with a maximum of 3 inches.
Reinforced walls and beams should have a minimum slump level of 3 inches with a maximum of 6 inches.
Aggregate
When you are ordering a concrete plant, you should know what the highest coarse aggregate is. This is determined by the ACI, and it is dependent on how much space is between the reinforced steel, as well as the aggregates that are available.
The largest aggregate must not be more than 1/5 of the smallest inside form dimension. It also cannot be more than 3/4 of the available space that is between the re-bars. It is typical for the structural engineer to give accurate direction and information when it comes to the sizing of aggregates.
After you have purchased your mini concrete plant, the company should provide continued customer support. Always double check with the company before signing any agreements with the salesperson.
For example, the salesperson may tell you that you will receive factory setup on your site, but the company does not honor this type of support. Be sure you know how tech support works and who is responsible if repairs are required onsite. Learn more: https://www.batchingplant.ru/.